1B3-2 R-4 AIR CONDITIONING COMPRESSOR
Figure 1— R-4 Compressor, V-Groove Pulley Type
with 4 Pole Clutch and Driver Shown
30 ml (1 oz.) is drained from the compressor, add the same
amount of new 525 viscosity oil to the overhauled assem
bly.
IDENTIFICATION
An identification label attached to the compressor pro
vides the name of the m anufacturer and model number
(figure 3).
DISASSEMBLY OF THE DRIVE COMPONENTS
CLUTCH DRIVE HUB
Remove or Disconnect (Figures 4, 5,
Tools Required:
J 9399 Thin Wall Socket
J 25008-A Holding Fixture
J 33027 Clutch Hub Holding Tool
J 37707 Clutch Plate and Hub Assembly
Remover
• Attach J 25008-A to the com pressor (figure 5).
• Mount J 25008-A in a vise (figure 6).
1. Shaft nut with J 9399 (figure 6).
• Hold the clutch plate with J 37707.
Figure 2— R-4 Compressor, Poly-Groove Pulley
Type with
2. Clutch drive hub (figure 7).
6
and 7)
3. Shaft key.
4 POLE CLUTCH ROTOR AND/OR
4 -+
Remove or Disconnect (Figures 4 , 8 , 9 , 1 0 and 11)
Tools required:
6
Pole Clutch and Driver Shown
Figure 3— Identification Label
• Thread J 37707 into the clutch plate and hub
assembly.
BEARING-V-GROOVE
J 6083 Snap Ring Pliers
J 9398 Rotor Bearing Remover