Cleaning The Heads; Controlling The Heater Elements - Oce CS9090 User Manual

Chapter 5: Handling the printer

5.5.2 Cleaning the heads

When there are some missing nozzles, a cleaning should be done. Depending on the quantity of missing
nozzles and which head, a little, normal or powerful cleaning on head 1-2, head 3-4 or ALL could be done.
Verify the following regarding the condition of the printer.
Step 1 :
It is not currently printing
I)
Press the [F2] key of the operation panel.
Step 2 :
To shift to the cleaning menu.
I)
Press the [F1] key or the [F2] key on the operation panel.
Step 3 :
The product will perform following operations:
I)
Setup items Key name
Cut & Feed F1
F2
Press the [ENTER] key to start the requested cleaning.
Step 4 :

5.5.3 Controlling the heater elements

If you want to change or check the heater elements, follow the steps below.
Verify the following regarding the condition of the printer.
Step 1 :
It is not currently printing
I)
Press the [F3] key of the operation panel.
Step 2 :
To shift to the heater menu.
I)
AP-75036 - Revision 1.3 – 20/03/06
Parameters
ALL, Head 1 – Head 2
Little, normal, powerful
The 'heater message' can be one of the following:
Heater standby
o
Heater warming up
o
Heater ready
o
'A' stands for the heater.
'B' stands for the fixer.
'C' stands for the post fixer.
'D' stands for the dryer.
'S' stands for the Set-temperature (requested temperature).
'R' stands for the Real-temperature (actual temperature).
130
Description
Clean ALL heads or head couple one or two
Set the intensity of a cleaning
User's Guide CS9000 series