Chapter 3: Setting up the unit
3.1 UNPACKING
The product comes in three boxes.
•
One with the printer body
•
One with the stand
•
One with the unwinder / winder 100 system
Please follow the instructions below to unpack the printer body and stand.
Caution
•
When unpacking this product, always work with at least 4 people.
•
When removing this product from the packaging box, always remove the vinyl plastic, and hold
on the side of the product. Holding the unit over the vinyl plastic wrapping can result in
slippage and dropping the unit, resulting in damage.
•
The unpacking of the unwinder 100 system is described in its stand alone manual which you
can find in the box of the motorized roll-off / roll-up system.
3.1.1 Unpacking packaging box of the main unit
Unpack the package of the main unit according to the following procedure.
Move the packaging of the main unit to the location to unpack.
Step 1 :
Remove the restraining bands.
Step 2 :
Remove the top board and take out the packaging material (right upper side and left upper side).
Step 3 :
AP-75036 - Revision 1.3 – 20/03/06
Top board
1
Packaging material (right upper side)
2
Packaging material (left upper side)
3
26
User's Guide CS9000 series