Activate/ Deactivate Heaters; Operating The Pressure Rollers; Print Mode Check - Oce CS9090 User Manual

Chapter 5: Handling the printer
5.5.3.5

Activate/ deactivate heaters.

In the second menu, press the [F1] key to activate or deactivate all heating elements.
In case the heating elements are activated, the display will mention "SET OFF". By pressing the [F4] key
you can deactivate the heating elements. The display will mention "SET ON".
In case the heating elements are deactivated, the display will mention "SET ON". By pressing the [F4] key
you can activate the heating elements. The display will mention "SET OFF".
Please note that after finishing a printing job (and no other print job is sent to the printer the heating elements
will keep their temperature for approximately 6 minutes. After 6 minutes the heating elements are powered
OFF.

5.5.4 Operating the pressure rollers

When you want to switch the up and down movement of the pressure rollers follow the steps below.
Press the [F4] key on the operation panel.
Step 1 :
The printer works as follows.
I)
Status of the printer
The pressure rollers have been lowered
The MEDIA SET lamp turns off.
The pressure rollers have been raised.
The MEDIA SET lamp turns on (orange).
Notes
You can also switch the up and down movement of the pressure rollers using the foot switch instead of the
operation panel.

5.5.5 Print mode check

Use the following procedure to check the print mode currently set.
Press the [ENTER] key on the operation panel.
Step 1 :
The following information is displayed on the operation panel for three seconds.
I)
No. Position
1 Line 2
2 Line 3
3 Line 4
When the printing mode display closes, the product changes to its normal status.
Step 2 :
AP-75036 - Revision 1.3 – 20/03/06
Line 2
Line 3
Line 4
Description
The printing quality is displayed.
The interlace method is displayed.
The printing direction is displayed.
Operation after the [F4] key has been pressed
The pressure rollers are lifted
The MEDIA SET lamp will turn on (orange).
The pressure rollers are lowered.
The MEDIA SET lamp will turn off.
Reference
Refer to 'Printing quality menu'
Refer to 'InterLace Setup menu'
Refer to 'Printing direction menu'
132 User's Guide CS9000 series