Oce CS9090 User Manual page 163

Open the front cover.
Step 4 :
Notes
Replace the cutting blade as quickly as possible. If you leave the carriage at the cutting blade replacement
position, the head may be clogged with ink.
While pressing the cutting blade holder tab, rotate the cutting blade holder lever in the direction
Step 5 :
shown in the diagram.
Notes
Do not push the cutting blade holder tab strongly or release it suddenly. Doing so may cause the spring
incorporated in the cutting blade holder to fly off.
Do not push in the cutting blade holder. Doing so may cause the cutting blade to damage the inside of the
printer.
Take out the cutting blade (1).
Step 6 :
Notes
Do not touch the edge of the cutting blade to avoid injury.
Do not drop the cutting blade or apply it on hard material. Doing so may damage or break the cutting blade.
Dispose the used cutting blade; put it in a plastic bag in accordance with local regulations or laws.
AP-75036 - Revision 1.3 – 20/03/06
1 Cutting blade holder lever
2 Cutting blade holder
163
Chapter 7: Maintenance
User's Guide CS9000 series