Oce CS9090 User Manual page 82

Chapter 5: Handling the printer
Check the printing result. See image below.
Step 3 :
When printing the distance adjustment has been finished, press the [CANCEL] key on the
Step 4 :
operation panel.
The following messages are displayed on the operation panel.
I)
Press the [F2] key on the operation panel.
Step 5 :
The following messages are displayed on the operation panel.
I)
Press the [F2] or [F4] key on the operation panel to set the distance adjustment value based on
Step 6 :
the printing result in Step 3.
Press the [ENTER] key on the operation panel to confirm the setup value.
Step 7 :
The operation panel shifts to the menu of the previous hierarchy.
I)
Repeat step 2-7 until good printing result has been obtained.
Step 8 :
Important
Some RIP software by default use USER 8 media type. In this case, changing the step adjust value
might seem not to have any effect. You can overcome this problem by first selecting USER 8 and
then changing the step adjusts for USER 8.
AP-75036 - Revision 1.3 – 20/03/06 82 User's Guide CS9000 series