Oce CS9090 User Manual page 53

Open the front cover.
Step 5 :
Caution
Be careful not to pinch your fingers when opening and closing the front cover.
Load the sheet media into the insertion slot at the front of the printer.
Step 6 :
Set the right edge of the media so that it is parallel with the media setting position.
Step 7 :
Notes
•
The media set position is a guideline for setting up the media.
•
If the right edge of the sheet media is 5 mm or more from the media setting position, a media set error
may occur if the media is not detected. Make sure to set the right edge of the sheet media within 5
mm of the media setting position.
Press the [F4] key on the operation panel to lower the pressure rollers.
Step 8 :
The MEDIA SET lamp will turn off.
Close the front cover.
Step 9 :
Step 10 : The media initial menu is displayed on the operation panel.
AP-75036 - Revision 1.3 – 20/03/06
Sheet media
1
Insertion slot
2
Sheet media
1
Media loading position
2
53
Chapter 4: Preparing for a job
User's Guide CS9000 series