Oce CS9090 User Manual page 143

(17) The printed lines are blurred.
No. Possible cause
1 You did not use recommended
media.
2 You used too thick or too thin
media.
3 You used bond media.
4 The printed surface is not the
printable side.
5 Did you try head cleaning?
(18) White or black lines on printouts.
No. Possible cause
1 You did not use recommended
media.
(19) Lines are missing.
No. Possible cause
1 The validity date of the ink cassette
has been expired.
2 You did not use recommended
media.
3 Did you try minor adjustments for
image quality?
(20) "Bubbles" near the Heaters.
No. Possible cause
1 You did not use recommended
media.
2 You did not set the correct heater
(21) Top Feed problem.
No. Possible cause
1 Media jam occurred due to a need
for Top feed.
AP-75036 - Revision 1.3 – 20/03/06
Solutions
Use recommended media.
Use recommended media
Use recommended media.
Pay attention to the
printable side to load
media correctly.
Perform head cleaning.
Perform strong cleaning.
Clean the surface of the
print head.
Perform long save
cleaning.
Solutions
Use recommended media.
Solutions
Use a new ink cassette.
Use recommended media.
Try minor adjustments for
image quality.
Solutions
Use recommended media.
Lower the temperature or
turn off the Heater
Solutions
Insert a minimum Top
Feed
143
Chapter 6: Troubleshooting
References
Refer to 'Media type'
Refer to 'Media type'
Refer to 'Media type'
Refer to 'Media handling'
Refer to 'Head cleaning'
Refer to 'Cleaning the cleaning
wiper'
References
Refer to 'Media type'
References
Refer to 'Replacing ink cassettes'
Refer to 'Media type'
Refer to 'Alignment'
References
Refer to 'Media type'
Refer to 'controlling the heater
elements'
References
Refer to 'Top Feed menu'
User's Guide CS9000 series