Media Cutting Procedure - Oce CS9090 User Manual

Chapter 5: Handling the printer

5.7.2 Media cutting procedure

This section explains how to cut the media manually.
When "Manual" is set in the media cut menu, the media can be cut manually.
Cut the media according to the following procedure.
Make sure that the MEDIA SET lamp on the operation panel is off.
Step 1 :
Notes
After printing, the media is automatically transferred to the media cutting position.
Press the [F3] key on the operation panel.
Step 2 :
Shift to the cut and feed menu.
I)
Feed media to the desired position according to the procedure in "Feeding media".
Step 3 :
Press the [F1] key on the operation panel.
Step 4 :
The following messages are displayed on the operation panel.
I)
Cut the roll media.
Step 5 :
Notes
When cutting roll media, be careful of the following. Incorrect handling can result in injury to the hands and
fingers from the cutting blade.
Press the [ENTER] key of the operation panel.
Step 6 :
The unit enters the normal status.
I)
AP-75036 - Revision 1.3 – 20/03/06 136 User's Guide CS9000 series