Chapter 3: Setting up the unit
3.3 ASSEMBLY
The assembly of this product is described below.
Caution
When assembling this product, always work with at least 4 people or more.
3.3.1 Assembling the stand
Assemble the stand according to the following procedure.
Place the stand upside down as shown in the figure.
Step 1 :
Install the foot to the stay according to the following procedure.
Step 2 :
Attach two feet on the bottom of the stay as shown.
I)
II) Tighten the feet with 8 times 1screws and two washers. Please refer to the picture below for
the correct order.
III) Tighten the assembly by using the hexagon wrench enclosed in the box.
AP-75036 - Revision 1.3 – 20/03/06
Stay
1
Foot
2
Hexagon socket head cap screw (M6 x 30)
4
Spring washer M6
5
Plain washer M6
6
32
User's Guide CS9000 series