Oce CS9090 User Manual page 10

Chapter 1: Safety Instructions
•
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
•
Be careful not to touch the heaters during or after operation. Doing so may result in burns.
•
Only use Océ IJC910 Low Solvent Ink and appropriate cleaning liquid.
•
Never open the covers fixed with screws, except the left cover. Doing so may result in electrical shock
or a malfunctioning in the printer.
•
Do not touch the cutter blade. Doing so may result in bodily injury.
•
Do not cut hard objects or drop the cutter. Doing so may damage or chip the cutter blade.
•
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction in the product.
•
Do not touch the cleaning wiper or the head cap unit whit bear hands. Use a dust free cloth and gloves
to clean.
•
Do not tilt the printer, stand it against a wall or turn it upside down. Doing so may cause ink to leak
inside the printer. Movement after transport is also not covered by the warranty.
•
When installing options, do not touch the elements on the circuit board. The elements on the boards can
be very hot and can cause burns.
•
Have four or more people unpack and assemble the printer.
•
When lifting the printer out of the packing box, be sure to remove the vinyl cover first, and then grab the
holding grips on the sides of the printer. Lifting the printer with the vinyl cover on may cause your hands
to slip and drop or damage the printer.
•
Have two or more people transport the printer.
•
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
•
Earth wires must be connected to wires or terminals that fulfill the conditions below.
Earth terminals of power sockets
Earth wires with copper morsel that is at least 650 mm under the ground
•
Earth wires must be connected to wires or terminals that fulfill the conditions below.
•
Keep the printer horizontal during transportation.
•
Be sure to do the following before attaching options.
Turn the printer off.
Unplug the power cord from the socket.
Unplug cables connected to the printer. Otherwise, damage to the printer or your computer may
occur.
Remove electrostatic charge from your clothes and body by touching the metal parts of the printer.
Electronic components such as the memory may malfunction if exposed to an electrostatic charge.
•
The equipment that you bought has required the extraction and use of natural resources for its
production. It may content hazardous substances for the health and the environment.
In order to avoid the dissemination of those substances in our environment and to diminish the pressure
on the natural resources, we encourage you to use the appropriate take-back system. Those systems
will reuse or recycle most of the materials of your end life equipment in a sound way.
If you need more information on the collection, reuse and recycling systems, please contact your local or
regional waste administration.
AP-75036 - Revision 1.3 – 20/03/06 10 User's Guide CS9000 series