Table of Contents
Advertisement
Chapter 4: Preparing for a job
4.6 MEDIA HANDLING
Media handling, attaching media, and setting media type are explained below.
4.6.1 Loading sheet media
The procedure for loading sheet media is explained below.
You can use the following sheet media with your printer.
Machine
CS9065
CS9090
To load sheet media, follow the steps below.
Notes
If roll media is attached to the printer, wind the media up and then load the sheet media.
Turn the printer on.
Step 1 :
The printer starts the initialize operation.
Step 2 :
The following message is displayed on the operation panel.
Notes
If you do not want to use the media detection at the media initialization: Set to "OFF" in the media
detection setup item.
Verify if the sheet lamp on the operation panel is unlit.
Step 3 :
Press the [F4] key on the operation panel to lower the pressure rollers.
Step 4 :
The MEDIA SET lamp will light (orange).
The following message is displayed on the operation panel.
Notes
When raising or lowering the pressurize rollers, you can use the foot switch instead of the operation panel.
AP-75036 - Revision 1.3 – 20/03/06
Media Width
1653 mm
2280 mm
52
Printing Width
1643 mm
2250 mm
User's Guide CS9000 series
Advertisement
Chapters
Table of Contents
