Oce CS9090 User Manual page 56

Chapter 4: Preparing for a job
P 2 : L
ART OADING THE MEDIA TROUGH THE FRONT TENSIONING SYSTEM
Load the media through the printer's pressure rollers.
Step 1 :
Standing in front of the printer, take the media and pull it until there is equal tension on the left
Step 2 :
and right of the media.
•
Do not pull the media in the middle.
Lower the pressure rollers of the printer.
Step 3 :
Set the unwinder (REAR) unit to AUTOMATIC.
Step 4 :
•
The rear tensioning system will go to its initial position.
Close the front cover.
Step 5 :
Start printing until the media reaches the front core of the winder OR feed the media without
Step 6 :
printing.
Use tape to fix the media end to the empty core installed at the winder unit. Start taping the
Step 7 :
middle of the media, then the both ends, applying equal tension on both ends.
Set the winder (FRONT) unit to ACTIVE. The front tensioning system will be activated.
Step 8 :
Notes
With a small intervention it is possible to reverse your winding direction.
Mount a cable between the control box and the front motorized unit cable.
Notes
You can use the roll-off foot switch during loading of roll media.
AP-75036 - Revision 1.3 – 20/03/06 56 User's Guide CS9000 series