Turning The Power Off - Oce CS9090 User Manual

Chapter 4: Preparing for a job

4.4.2 Turning the power OFF

Turn the power of the unit OFF according to the following procedure.
Verify the following regarding the operational condition of the unit.
Step 1 :
There is no printing operation being performed.
The operation panel is in a normal status.
Press the [POWER] key of the operation panel to turn the unit OFF.
Step 2 :
Following message is displayed for 3 seconds on the operation panel.
Step 3 :
Notes
If pressing the [POWER] key on the operation panel by mistake, press the [POWER] key again while the
following message is displayed.
The product will perform the power OFF operation.
Step 4 :
Following message is displayed on the operation panel.
All lamps and the LCD of the operation panel will turn OFF.
The product will automatically turn the power OFF after performing a tubing flush.
Notes
If there are problems during the power OFF operation, the unit will display a message on the operation
panel, and the operation may stop. If the operation stops, refer to "Troubleshooting" and take the
appropriate actions.
AP-75036 - Revision 1.3 – 20/03/06 46 User's Guide CS9000 series