Oce CS9090 User Manual page 69

B. Printer mode
Transferring ink volume and printing is performed in 2 stages. See the step – action table below :
Stage Description
1 Transferring ink volume to the chip manager
system. See image Stage 1 below.
2 Printing with the total ink volume on the chip
manager system. See image Stage 2 below.
Stage 1 : Ink volume transfer BEFORE printing
Stage 2 : Ink volume transfer WHILE printing
More info about Stage 2 :
In the printer mode, the smartchip management system reads out the ink volume on the smartchip card in
the smartcard reader. If no valid card or no ink volume is found, the ink manager system will scan all
cassette slots. It is then possible to transfer the ink value rest on the smartchips. In that case, the ink
manager system will add all the ink volumes together to a TOTAL INK VOLUME, independent from the ink
colour.
See 4.9.3 Inserting a smartchip card in the card reader of the printer on next page for more details about
the procedure.
AP-75036 - Revision 1.3 – 20/03/06
User's Action
Ink volume transfer,
Transferring the ink
volume from the
smartchip cards to
the smartchip
management
system on next
page.
Printing the print
data.
69
Chapter 4: Preparing for a job
Remark
none
This ink volume
transfer is
AUTOMATICALY
performed during
printing
User's Guide CS9000 series