Introduction; Connecting The Power Cable - Oce CS9090 User Manual

Chapter 4: Preparing for a job

4.1 INTRODUCTION

The procedures needed before using the printer are explained below.

4.2 CONNECTING THE POWER CABLE

The connection procedure for the power cable is explained below.
Important
•
Make sure that the distributed power cable is used. Use of a different cable may result in
electric shock or fire.
•
Do not use a damaged power cable. Doing so may result in electric shock or fire.
•
The disconnect device is the plug on the power supply cord.
Caution
•
Be careful of the following when handling the power cable.
Do not make any modifications to the power cable.
o
Do not place anything heavy on the power cable.
o
Do not bend, twist, or pull the cable.
o
Do not wire the cable near equipment that generates heat.
o
Notes
•
If the power cable is damaged, contact one of the following :
The shop where you bought your Océ printer.
o
Your local Océ representative.
o
To connect the power cable, follow the steps below.
Make sure the printer is powered OFF.
Step 1 :
Notes
When the printer is ON, the power LED is lid green. Push the power button again to turn off the machine.
AP-75036 - Revision 1.3 – 20/03/06 42 User's Guide CS9000 series