Oce CS9090 User Manual page 9

•
Be sure to use the attached cable. Otherwise, electrical shock or fire may occur.
•
Be sure to use the specified voltage (AC 100 V to 120V, or AC 220V to 240V). Otherwise, electrical
shock or fire may occur.
•
Use electricity directly from a power outlet (AC 100 V to 120V, or AC 220V to 240V). Do not put many
loads on one electrical output. Otherwise, heat may be generated and cause fire.
•
Be sure to use an outlet with an earth terminal and use the terminal correctly. Otherwise, electrical
shock or fire may occur.
•
Follow the instructions below when handling the power cable.
Do not modify the cable.
Do not put heavy objects on the cable.
Do not bend, twist or pull the cable.
Do not wire the cable near equipment that generates heat.
•
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
Wipe away dust and any other residue before inserting the plug.
Ensure that the plug is firmly inserted as far as it will go.
•
When handling the foot switch, be aware of the following:
Do not place anything heavy on the foot switch.
Do not bend the cable of the foot switch with force and do not pull.
Do not place the foot switch near thermal devices.
•
When handling ink cassettes, be careful that ink does not get in your eyes or on your skin. However, if
this happens, flush immediately with water and wash skin with soap. Otherwise, your eyes may become
congested or inflamed slightly. If you feel discomfort, consult a doctor immediately.
•
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
•
Océ IJC910 Low Solvent Inks
General information:
Symptoms of poisoning may even occur after several hours; therefore medical observation for at
least 48 hours after the accident.
After inhalation:
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if
symptoms persist.
In case of unconsciousness place patient stably in side position for transportation.
After skin contact: Generally the product does not irritate the skin.
After eye contact: Rinse opened eye for several minutes under running water.
After swallowing: Seem medical advice or consult doctor.
•
Be careful not to pinch your fingers when opening and closing the cover of the ink compartment.
•
Be careful not to pinch your fingers when opening and closing the front cover.
•
Follow the instructions below when connecting the network interface cable. Otherwise, electrical shock
or fire may occur.
Do not touch the connector.
Do not connect the network cable connector that is not the same specification to the interface board.
•
When cutting the roll media, be careful of the following. Incorrect handling can result in injury to the
hands and fingers from the razor blade.
When holding the media, do not place fingers over the media cut groove.
Move the razor blade slowly along the media cutting groove.
•
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
AP-75036 - Revision 1.3 – 20/03/06 9
Chapter 1: Safety Instructions
User's Guide CS9000 series