Channel-Related View Change - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
3.2.2

Channel-Related View Change

3-4 Parameters
The views listed below can be activated in a channel strip. Then the corre-
sponding values of this particular channel are shown.
• Dynamics (by touching the green dynamics view on the screen)
• EQ (by touching the red EQ view on the screen)
• Panning (by touching the yellow pan view on the screen)
• Bus Assignment (by pressing VIEW: BUS ASN – as opposed to the GLOBAL
VIEW: BUS ASN key described in chapter 3.2.1).
• Channel parameters (by pressing VIEW: CHANNEL); this shows the
remaining controls, together with AUX AND covers all 40 rotaries.
• Miscellaneous parameters (by pressing VIEW: MISC); this shows a reduced
view of EQ, dynamics, and pan parameters at the same time; it covers all
40 rotaries.
When touching a curve on the TFT, a picture with the available parameters
appears on the rotaries. The picture is 'left-aligned' to the selected channel.
When touching the dynamics curve of the third channel strip, for instance, the
corresponding graphics are shown on the rotary rows 3 through 7, since the
dynamics parameters are covering five rows of rotaries. While the function
is unfolded on the display, the corresponding graphic field (e.g. showing the
dynamics curve) is highlighted, as shown in the picture at the left.
In one fader bay, two audio functions can be shown at a time, either by using
the MULTI SEL key, or by simultaneously touching two graphics. In this case,
one of the two functions is displayed left-aligned, the second one right-
aligned. If there is any room between them, they are interleaved by one or
more strips in black. The rotaries on these blackened strips are not used.
SW V4.5 Date printed: 27.0.0