Signal Out Configuration - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
4.6.4.4.2

Signal Out Configuration

4-2 GC Operation
This action will open the Edit relay labels page and first allow selection of the
desired relay, and then to enter a User Label for each relay. Be sure to click
ok when finished; otherwise all changes will be lost.
The fixed relay labels have been automatically generated by the Vista
system. They have the format SIGOUT0_REL01, where SIGOUT0,
SIGOUT1, etc. define the relay card number, and REL01, REL02, etc.
define the relay number on a particular card.
There are 16 relays per card. Some of the physically present relays may be
assigned to internal system functions and may therefore not be available for
the Signaling Configuration.
Source labels can be edited in the Patch pages; refer to chapters 4.4.2 and
4.4.3.
Signaling Outputs are generally relay contacts installed in the Monitoring
frame. They may be used for various purposes, such as:
• Fader Start
• Microphone ON actions (loudspeaker muting, etc)
• Parallel Record/Ready mode of tape machine tracks.
SW V4.5 Date printed: 28.0.0