Control Mode Entry; Global Mode Entry - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
5.6.5

Control mode Entry

5.6.5.1

Global mode Entry

Glo­bal Co­ntro­l Mo­de Entry The primary method to enter automation Control Modes is using the Control
Preselectors
Global Mode Activators
Glo­bal Mo­de Activato­rs There is an activator key for each Control Mode. Pressing one of these keys
5-4 AutoTouch+
Controls may be put into the various Control Modes using one of four meth-
ods:
1. Globally using the Global Control Mode Activator keys and other controls
on the AUTOMATION Panel.
2. Locally using the channel strip AUTO MODE key.
3. When AutoTouch+ is turned On using the MIX ON key on the AUTOMA-
TION Panel. Activating the system will engage the Control Mode selected
on the Panel Presets Options page.
No­te Multiple Control Modes may be active on the console simultaneously.
Mode section of the Master Automation Panel. Controls that are to enter the
mode are 'preselected' using Control Mode preselector keys. The preselected
controls are then entered into the desired mode using the Global Mode Activa-
tor keys.
puts the preselected controls on all channels into that mode. The controls af-
fected are filtered by the preselectors that are currently active. For example,
when only the Fader preselector is active and the Write Enable activator is
pressed, only the faders on all channels will change to WRITE ENABLE. Any
other Control Modes that were set on controls other than faders will retain
their mode state <Optio­n>.
No­te When a Global Mode Activator key is lit, it indicates the Control Mode for
all channels. Mode changes made on individual channels will cause the light
to go out. Resetting all the Control modes to match on the local level will not
cause Global Mode Activators to re-light.
SW V4.5 Date printed: 28.0.0