Pro-Bel P-08 Support - Studer Vista 9 Operating Instructions Manual

4.7.2.1.1

Pro-Bel P-08 support

IO/InterfaceType/BoardNumber/PortNumber/ChannelNumber/PatchNumber,Index,Matrix,Level,
InterfaceType 1 = AES in, 3 = Madi in, 9 = IO21 in
BoardNumber Certain interfaces use board numbers
PortNumber Certain interfaces use port numbers
ChannelNumber Interfaces do not use channel numbers and it's usually 0
PatchNumber The zero-based index of the patch of the selected board and port
Index, Matrix Index and Matrix as defined in the Probel specification
Date printed: 28.0.0
In case the user wants to extend the number of controlled patch points to above
1'000 it is recommended to use the Pro-Bel P-08 protocol. This protocol also
supports transferring labels from 3
chapter 4.7.2.1.3). However, no control over internal patches such as patching
from an input port to an input channel is provided. Only one port can be used
for P-08. Therefore continue to use P-02 in case of multiple controllers present
or if you want to set system internal patches, e.g. channel input patches.
A special mapping file is present in the system translating Vista interfaces to
Pro-Bel P-08 commands (no 'fixed labels' used):
Pro-Bel SW-P-08 Issue 21
2/1/0/0/0/0,1,1,0,
2/1/0/0/0/1,2,1,0,
2/1/0/1/0/0,2,2,0,
2/1/0/1/0/1,1,1,5,
2/4/0/0/0/0,9,0,0,
2/4/0/0/0/1,0,9,0,
2/4/0/1/0/0,0,0,9,
The format is as follows:
4 = AES out, 8 = Madi out, 10 = IO21 out
Level Level is evaluated for sources only. As this might be used differently with
OnAir 3000 systems, we recommend using 0 for the Level.
SW V4.5
Vista 9 Digital Mixing System
party router systems at the same time (see
rd
GC Operation 4-