General; Utilization For The Purpose Intended; First Steps; Unpacking And Inspection - Studer Vista 9 Operating Instructions Manual

1

General

1.1 Utilization for the Purpose Intended
1.2 First steps
1.2.1 Unpacking and Inspection
1.2.2

Installation

Primary Voltage
Power Connection
Earthing
Thermal Considerations
Principal Rule The cooler the better – a temperature increase of only 10° C reduces compo-
Date printed: 28.0.0
The SCore Live system is intended for professional use.
It is presumed that the unit is operated only by trained personnel. Servicing
is reserved to skilled technicians.
The electrical connections may be connected only to the voltages and signals
designated in this manual.
Your new system is shipped in a special packing which protects the units
against mechanical shock during transit. Care should be exercised when
unpacking so that the surfaces do not get marred.
Check the condition of the equipment for signs of shipping damage. If there
should be any complaints you should immediately notify the forwarding agent
and your nearest Studer distributor.
Please retain the original packing material because it offers the best protection
in case your equipment ever needs to be transported.
The power supply units are auto-ranging; they can be used for mains voltages
in a range of 100 to 240 VAC, 50 to 60 Hz.
The attached female IEC 320/C13 mains cable sockets have to be connected
to appropriate mains cables by a trained technician, respecting your local
regulations. Refer to the 'Installation, Operation, and Waste Disposal' chapter
at the beginning of this document.
This equipment must be earthed, due to the mains input filter network being
connected to the mains earth.
Some consideration must be given to the earthing arrangement of the system,
at the center of which is the frame. The frame is earthed to the mains earth
via the power supply. Ground loops may occur where signal processing equip-
ment, patched to the frame, has its signal earth commoned to the equipment
chassis.
The unit must not be used in conditions of excessive heat or cold, near any
source of moisture, in excessively humid environments, or in positions where
it is likely to be subjected to vibration or dust. The ambient temperature range
for normal operation of the unit is +5...+40° C.
Under standard circumstances (open 19' frame) and an ambient temperature
between +5 and +40° C, the power dissipations listed below must not be
exceeded. Please note that these figures may change for special environments,
such as air-conditioned machine rooms, etc.
nent lifetime by 50%!
SCore Live
SCore Live