Gc Menu Items - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
Reco­rd Recalled VMC Values To record Snapshot or Preset values to controls, use the following proce-
5.12.3

GC menu items

Auto­matable Optio­n Menu Items The following Option menu items contain automatable controls:
Menu Item Behavio­r T he GC menus do not have dedicated automation controls. The current global
5-92 AutoTouch+
dure:
1. Select the desired global Control Mode.
2. Select TOUCH RECORD.
3. Select the desired 'Write To:' function (Trim will default to 'Next
Change').
4. Open the Snapshot page in the GC if it is not already open.
5. Recall the desired Snapshot or Preset.
6. Global conditions will apply to the controls that were enabled.
7. When timecode is stopped, a new Mix Pass will be generated.
No­te Recalling the channel strip clipboard has the same affect as recalling a
Snapshot or Preset, except values are only applied on one channel at a time.
Recording recalled clipboard values may be done as described above.
Some operational GC menu items may be automated. During normal opera-
tion, these items are found in the GC Option menu. However, since all VMC
objects are available in the ShowVMCTree menu (in the SysAdmin menu),
these menu items may be automated as well.
• Meter/Generator: Global channel Meter locations and Generator pa-
rameters may be automated. Changes made to these items will produce
Touch/Un-touch events.
• N–1 Assignments: N–1 Assignments may automated. Changes made to
these assignments will produce Touch/Un-touch events.
• Control Group Filter: Changes made within each Control Group may be
automated. Changes made within a Control Group will produce Touch/Un-
touch events.
• VSP Microphones and Reverb: Changes made Reverb Bus Assignments
and Microphone Characteristics (polar pattern and placement) may be
automated. Changes made within the VSP Microphones and Reverb menu
items will produce Touch/Un-touch events.
automation modes apply to the automatable GC menu items. For an Option
menu item use either the SW (SWIT) or ENC (KNOB) preselectors to select
global modes, depending on item to be automated. For 'ShowVMCTree'
items, any preselector may be used, depending on the controls/functions the
user wishes to enable.
Menu item switches and selectors will follow the rules of a Press and Release
switch operation, refer to chapter 5.10.3.1. All Mix Pass 'Write To:' and 'Ex-
tend Back To:' conditions apply.
As with any control, changes to menu items may be auditioned.
SW V4.5 Date printed: 28.0.0