Cue List Options Menu - Studer Vista 9 Operating Instructions Manual

4.4.5.2.15

Cue List Options Menu

Default Crossfade Options
Switch Options Describes the behavior of switches (e.g. MUTE, EQ on/off etc.) during a cross-
Default Crossfade Time Set default value of cross-fades when new cues are created (enter in
Enable Trim Mode When pressing-and-holding the ISO key on the channel strip followed by tou-
Enable Partial Snapshots Activates the 'Partial Snapshot' feature. It will be possible to include only
Cue List
Enable Theatre Cue List Enables extensive functionality of cue lists.
ONAIR arms Cue List When pressing LIVE in the EXT PFL SPEAKER area of the Vista 8 control bay,
Show Next Cue when Armed Defines whether the currently active or the next cue should be highlighted
Restore Armed on Startup The system will switch the console into the 'armed' state whenever the
Enable VCA Events See chapter 4.4.5.2.10.
Unmute/Mute VCA Members See chapter 4.4.5.2.11.
MIDI Show Control Device ID See chapter 4.4.5.2.8.
Date printed: 28.0.0
In the 'Option - Snapshot Automation Options' menu the following options
are available:
The system allows cross-fading between two cues. The default cross-fade
values may be defined here. These will be used whenever a cue is created.
fade. They apply if a switch changes its state in the next cue. They may change
their state before, during, or after the cross-fade.
seconds).
ching individual controls (e.g. faders, rotaries), their state can be isolated from
snapshot recalls. If this option is on, the particular parameter may be touched
a second time. This will set it into Trim mode. In this mode all changes to
that parameter since the last snapshot recall will be applied relative (!) to all
upcoming snapshot recalls – thus, not modifying them on disk.
ganged channels when making a snapshot. Options are available within the
snapshot window of the GC screen.
the state of the cue list will change accordingly.
when the cue list is armed. This also allows reading the attached notes ahead
during the live event.
software is started. This allows e.g. constant reception of external MIDI
commands for firing off cues.
SW V4.5
Vista 9 Digital Mixing System
GC Operation 4-