Touch Record + Touch Hold - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
To­uch Ho­ld With only TOUCH HOLD engaged (without TOUCH RECORD), Touch events
5.7.4

Touch Record + Touch Hold

5-5 AutoTouch+
perform the following functions when dynamic controls are in the Control
Modes indicated (remember Un-touch events are suppressed):
• READ: Touch will change to and stay in AUDITION.
• WRITE ENABLE: Touch will change to and stay in AUDITION.
• TRIM ENABLE: Touch will change to and stay in TRIM AUDITION.
• ISOLATE: Touch/Un-touch events of Isolated controls are not recognized
by AutoTouch+.
<Optio­n> • With <Read Safe> checked on the Misc Options page (see chapter 5.21.7),
AUDITION mode is defeated for controls in READ, and only written
values will be heard.
• The TOUCH HOLD key may be overridden by checking options on the
<Master Panel Overrides> section of the Master Panel Options page (see
chapter 5.21.5). Faders and Encoders can have TOUCH HOLD set to <ON>,
<OFF>, or to follow the Master Panel <Follows Panel>. TOUCH HOLD for
Switches can also have <ON> and <OFF> overrides or be set to follow
the Master Panel <Follows Panel>.
TOUCH RECORD and TOUCH HOLD can be used together to create a condition
where controls will change to RECORD (if currently enabled) or AUDITION
(if currently in READ) when touched and stay in that mode when released.
With both TOUCH RECORD and TOUCH HOLD engaged, touching a control
will change it from its current state to the next mode available and then will
'hold' that mode (remember, when TOUCH HOLD is activated, the Touch event
is registered by the system and the Un-touch event is suppressed).
When released, a control in RECORD will not punch-out and change back
to ENABLE, it will stay in RECORD. Likewise a control in AUDITION will
not revert to READ when released.
SW V4.5 Date printed: 28.0.0