5.11 Graphical Controller Automation; General Patch - Studer Vista 9 Operating Instructions Manual

5.11 Graphical Controller Automation

Auto­mated Items Automatable items in the Graphical Controller are as follows:
5.11.1

General Patch

Co­nnectio­n Behavio­r T he General Patch does not have dedicated automation controls. The current
Date printed: 28.0.0
As discussed in the Switch Automation chapter, controls that are defined in
the VMC may be automated. While most of these controls are work surface
oriented, some controls are found only in the Graphical Controller.
• General Patch Connections
• Channel Patch:
- Input Selector
- Processor Block Order
- Dynamic Sidechain Link Setup
- Dynamic Sidechain Link Enable
- Dynamic Key Input Routing
- Direct Output Tap Location
- Meter Feed Tap Location
Connections within the General Patch may be automated. Both 'Make Con-
nection' and 'Break Connection' operations may be stored as Static objects
or recorded as Dynamic objects. All types of General Patch connections may
be recorded.
global automation modes apply to the General Patch. The SWIT preselector
must be used to select global modes.
General Patch connections follow the rules of a Press and Release switch
operation. Refer to chapter 5.10.3.1.
SW V4.5
Vista 9 Digital Mixing System
AutoTouch+ 5-85