Autotouch+ Panel Survey - Studer Vista 9 Operating Instructions Manual

5.18 AutoTouch+ Panel Survey

ENABLE MODES (see also chapter 5.6)
G lobal ENABLE MODES Preselectors (see also chapter 5.6.5.1)
Date printed: 28.0.0
READ – Sets selected objects (depending on the preselector setting) into Read
mode.
WRITE – Sets selected objects (depending on the preselector setting) into
Write Enable mode. These parameters are 'armed' and can be put into write
(record).
TRIM – Sets selected objects (depending on the preselector setting) into
Trim Enable mode. These parameters are 'armed' and can be put into trim
(record).
ISOLATE – Isolates selected objects (depending on the preselector setting).
These objects will not be affected by the automation.
Before any enable mode (READ, WRITE, TRIM and ISOLATE) can be globally
activated, the preselectors for the desired objects must be activated. These
are:
FDR (faders) – all faders
MUTE – all mutes
KNOB (rotary encoders) – all continuous controller-type encoders, except
knobs used for selections
SWIT (switches) – all switches
HELD (held controls) – all controls that are currently in a 'held' state. This can
be any combination of faders, mutes, encoders and switches. Refer to chapter
5.7.3.
CLR / ALL (Clear/All) – Permits changing of all preselectors at once.
• If one ore more preselectors are active, CLR / ALL clears all of them
• If none of the preselectors are active, CLR / ALL activates all of them.
• If CLR / ALL and a global enable mode (e.g. WRITE) is pressed, this brings
all controls into WRITE (as if preselectors were bypassed).
SW V4.5
Vista 9 Digital Mixing System
AutoTouch+ 5-9