Sysadmin: General Patch/Probel Setup; Rd -Party Control Of Console Patch (Native Pro-Bel P-02/08 Support) - Studer Vista 9 Operating Instructions Manual

4.7.2

SysAdmin: General Patch/ProBel Setup

4.7.2.1 3 -Party Control of Console Patch (native Pro-Bel P-02/08 Support)
rd
Supported Functionality Our implementation enables the ability to map certain Pro-Bel connect
Date printed: 28.0.0
A Source or Target can be assigned to any of the Subclasses, but only to one
Subclass at a time.
To reassign an item or items from a Subclass, use the same selection tech-
niques as above. Then you can:
• Click on the Clear Subclass button to remove the selected items from the
Subclass. This will return the selected items to the Digital Input or Digital
Output Patch Section;
• Click on a different Subclass button to directly re-assign the selected items
from the current Subclass to another Subclass.
The result of this process is that the subclassified sections are now visible in
the Patch lists and can be directly accessed using the right trackball button.
For details, refer to chapter 4.4.2.3.
Notes: Subclass names are saved and recalled with User Preferences.
Assignment of individual interfaces to subclasses is saved in each Snapshot
Preset and can therefor vary from Snapshot to Snapshot.
There is only one accessible item in this menu: Subclassifying the Digital In
and Digital Out Interface Sections of the Patch.
Since version 3.5 of the Vista Software, these products are able to support
Pro-Bel enabled devices natively, and so a second PC is no more necessary for
this functionality. However, we do not recommend that existing installations
are altered that are already in use with a second PC for Pro-Bel interfacing.
The explanations below are therefore intended for installation personal and
not for the console operators.
requests to a set of definable patch connections. The control of patch points
is not restricted to set output patch points. It is possible to set any patch points
within the console patch upon reception of a Pro-Bel command. The set-up
procedure is done from the General Patch screen, where certain patches can
be selected (by just selecting the affected targets) and which are being mapped
to a Pro-Bel source/destination combination with a single click on a dialog.
SW V4.5
Vista 9 Digital Mixing System
GC Operation 4-