Area 6 - Studio Monitoring - Studer Vista 9 Operating Instructions Manual

2.4.6 Area 6 – studio Monitoring
Date printed: 27.0.0
A – B
Selects the Studio A or B for which the controls are currently active.
SEL – FOLW CR – PFL / SOLO
Determines whether the studio is fed with:
• what is selected on the SOURCE SELECTOR (32 keys),
• the same source as the control room, or
• the PFL/SOLO signal only.
 A: RED LIGHT – B: RED LIGHT
Indicates active red light. Can also be pressed in order to
switch the red light on/off manually, if not already activated
by e.g. open faders.
 A: SIG 1 – B: SIG 1 – A: SIG 2 – B: SIG 2
Two GPIOs (general-purpose I/O – with optocoupler inputs
and either open-collector or relay outputs) are assigned to
these keys for signaling purposes (refer to the talkback and
signaling block diagram in chapter 2.4.7).
 A: TALK – B: TALK
Shortcut keys for talkback to the two studios.
 RE-INJECT
If the studio is muted by an active RED LIGHT, this key allows to inject the
signal anyway.
Please note that, depending on the installation and the current level, this
might result in acoustical feedback.
 MUTE –  DIM
Keys for muting or dimming the studio speakers. DIM level may be adjusted
in the monitoring.ini file by experts only.
LEVEL
Level control for the studio speakers.
SW V4.5
Vista 9 Digital Mixing System
Desk Operation 2-2