Vista Settings - Studer Vista 9 Operating Instructions Manual

7.2

Vista Settings

Specify MIDI Ports (i.e., MIDI ports used for DAW Control)
Define Network Card Define which network card of the Vista is used for DAW control:
Date printed: 29.0.0
ipMIDI (to be installed on Vista console PC)
• Install ipMIDI v1.6 (requires DirectX 8.1 or later)
• Deactivate 'Loop Back' (un-tick the checkbox in the ipMIDI monitor
window)
• Define four ports in the ipMIDI monitor window
• Restart the Vista console PC
• While using ipMIDI, add the following two lines into D950system.ini as
shown below. (Please note: the entry is case sensitive).
[Midi]
DawPorts="Ethernet MIDI"
• Set a persistent route by entering the following command to the command
line on the Vista
route add 225.0.0.0 MASK 255.255.255.0 x.x.x.x –p
(x.x.x.x is the static IP address of the network card connected to the DAW)
In order to check whether the route has been set correctly, use the com-
mand:
route print
(refer to the screenshot below)
SW V4.5
Vista 9 Digital Mixing System
DAW Control 7-5