Xfade Active; Preview; Midi Show Control Device; Midi Port Deactivation - Studer Vista 9 Operating Instructions Manual

4.4.5.2.6

XFade Active

4.4.5.2.7

Preview

4.4.5.2.8

MIDI Show Control Device

Examples
Previous Cue: F0 7F [Device ID] 02 11 12 F7 (Standby Command), then
Recall Cue 3.5: F0 7F [Device ID] 02 11 01 33 2E 35 F7 (Go Command with Q specified)
4.4.5.2.9

MIDI Port Deactivation

Date printed: 28.0.0
It may be useful to temporarily disable cue cross-fades (e.g., during rehear-
sals). This can be done by un-checking this item.
The snapshot/cue preview mode can be activated either by a hardware key or
by clicking on the button located in the top right corner of the cue list window.
When in preview mode, the cue or snapshot currently selected (single click)
is compared to the current audio settings. If there is a difference, Vistonics
shows both values at the same time, using a pink graphical indication. When
pressing the dedicated snapshot keys above the trackball, the preview mode
is automatically activated until the same key is pressed again.
It is possible to control the cue list by using 'MIDI Show Control' commands.
Vista 8 acts as a slave in this case. The following 'MIDI Show Control' com-
mands are supported: Go, Stop, Resume, Load, Reset, Standby+, Standby–,
Sequence+, Sequence–.
Vista is designated as a Music Command Format (0x11). The MIDI device
ID is set in the 'Option: Snapshot Automation' menu.
Next Cue: F0 7F [Device ID] 02 11 01 F7 (Go command)
F0 7F [Device ID] 02 11 01 F7 (Go Command)
For enabling or disabling (cutting) the MIDI control input and output ports,
two of the OPTION keys on the console are used, as shown below. The cor-
responding key flashes as long as the port is disabled. The function keys are
assigned as follows:
F1 – CUT MIDI In
F2 – CUT MIDI Out
F3 – Toggle Blackout
F5 – Update VCA/Mute
F6 – Update Snapshot
The MIDI In port can be disabled, in addition (together with the blackout
function as well as the hardware NEXT and PREVIOUS keys on the console
surface) using the ARM CUELIST button in the theatre cue list. Different
options for this button can be set in the Option - Snapshot Automation
menu.
SW V4.5
Vista 9 Digital Mixing System
GC Operation 4-
™