D950System.ini - Studer Vista 9 Operating Instructions Manual

# Multicast
# -------------
# If you use IGMP multicasts instead of broadcasts in your network,
# you have to uncomment the lines below. It is possible that a
# container is member of one or more than one multicast groups.
#
# NOTE: For an optimal performance, make sure that all network resources
# (Switches, Routers...) support IGMP.
#
# NOTE: To avoid IP conflicts, check the available addresses for
# multicast groups (www.iana.org). Use preferable addresses from the
# local scope (239.255.0.0/16) described in RFC 2365.
#
# NOTE: If the multicast should reach computers beyond the local subnet
# Set MulticastTimeToLive > 1 (1 is default)
# MulticastGroup = 239.255.0.1
# MulticastGroup = 239.255.0.2
# MulticastGroup = 239.255.0.3
# MulticastTimeToLive = 10
# Multiple Network Adapters
# -------------------------------------
# When more than one network adapter is enabled on the computer, the MAC Address has to be specified
#
MAC = 00-AA-11-BB-22-CC
8.5.5

D950system.ini

Date printed: 29.0.0
 Multicast groups should all be disabled
 in case of a Vista 6/7/8 with multiple network adapters, they need to be specified here
The following entry needs to be added in the D950system.ini file:
IsRelinkActive=Yes
SW V4.5
Vista 9 Digital Mixing System
RELINK 8-5