Auto Punch-In/Out; Auto Gpi In/Out - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
5.8.4 Auto Punch-in/o­ut
Write Zo­ne To set up an Auto Punch-in/Out, a 'Write Zone' with a 'Begin' and 'End'
Auto­ Punch-in To activate the Auto Punch-in feature, the Write Zone must first be enabled,
Perfo­rming the Punch Once Auto Punch-In is enabled and the desired controls are enabled, play back
5.8.5 Auto GPi in/o­ut
5-8 AutoTouch+
Automatic punch-in/punch-out is controlled via the AutoTouch+ window of
the GC.
time must first be established. These will be the In and Out point for the
Auto Punch-in. The times displayed were the last In and Out times used by
the system. Direct entry of Begin and End times is possible once the Write
Zone is enabled. Refer to chapter 5.8.3 for details.
which is done by checking the 'Enable' box next to the End time field. Once
the Write Zone is enabled, it is then possible to enable the Auto Punch-in
facility. This is accomplished by checking the 'Auto PUNCH-IN' box located
below the Write Zone Enable box.
timecode (media). During the pre-roll before the Begin Time, the affected
controls will act as if in RECORD ENABLE, but will not punch-in until the
Write Zone Begin time.
At the Begin time, the system will automatically punch-in and the any enabled
controls will change to RECORD. Recording will continue until the End time
is reached, where the controls are automatically punched out.
No­tes It is possible to punch-out any individual control at any time within the Write
Zone using the AUTO MODE key. Global punch-outs may also take place be-
fore the end of the Write zone. It is not possible to punch-in before the Begin
time or after the End time when the Write Zone is enabled.
Glide functions may be used with Auto Punch-In/Out. Since changes to the
Read Mix are prohibited after the Write Zone End time, the Backtime Glide
function must be used if Auto Punch-out is used.
Global Punch-Ins and Punch-Outs can also be done via the GPI input. This
will basically make the Punch-In and Punch-Out key available to external
systems or external keys.
If such functionality is required, the
accordingly. Please contact Studer Service & Support to do the necessary
changes in that file.
SW V4.5
file needs to be adapted
Signaling.ini
Date printed: 28.0.0