Glide - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
Mo­de Enable sets no­n-selected to­ READ
5.21.3

Glide

Glide at Punch-Out When a control is punched out of Record into Playback the control will glide
5-54 AutoTouch+
Normally you can use the preselectors in combination with the Control
Mode activators to set various control types into different Control Modes.
For example, you could select FDR (only) and hit WRITE and the faders
will all go into WRITE. You could then hit CLR and ENCoders and then hit
TRIM and the knobs will be in TRIM, while the faders are in WRITE. This is
very flexible and useful, but if you want to ensure that only specific controls
are in a specific mode (like making sure that the Faders are in WRITE and
everything else is in READ), you would have to select all the preselectors
(or Hold down the CLR/ALL key) and hit READ. Then select FDR and Hit
WRITE. However, when this option is set, you are always assured that when
you hit an Control Mode activator, all control NOT active on the preselectors
will be set to READ when the selected controls are set to the activator mode.
For example, if only FDR selected on the preselector and the TRIM activator
is hit, it is assured that every control other than faders will automatically be
set to READ mode.
from the punch-out value to the read mix value over the time period as set by
the Glide Time setting. The system attempt to recalculate the glide vector after
each frame so an attempt is made to have the actual glide duration match the
set glide time as closely as possible. However, if the read data is approaching
the gliding control quickly, the glide duration may be shorter than the actual
setting. In no cases will the time be longer. This behavior is consistent with
good mixing practice.
SW V4.5 Date printed: 28.0.0