Control Bay View - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
2.7.3

Control Bay View

2-4 Desk Operation
By clicking into the fader area of one of the fader bay icons (Faderbay ...),
the ten corresponding faders are shown instead of the Vistonics screen. The
central fader on the right is then hidden. The lower part of the selected fader
bay icon is highlighted – in order to make clear which bay the operator is
looking at.
Operation The hardware keys and buttons (also the keys next to the rotary encoder knobs)
on the screen can be operated by clicking on them either with the right or left
mouse/trackball buttons.
Rotary encoder knobs can be operated by clicking-and-holding them with
the left mouse/trackball button (this corresponds to touching the real encoder
knob on the desk surface); the parameter value is then underlined and dis-
played below the label area in addition. By moving the mouse or trackball
to the right or upwards (or anything in-between) the parameter value is
increased; by moving it to the left or downwards (or anything in-between)
the parameter value is decreased.
The control bay view can be selected from the desk overview area at the
bottom of the screen. By clicking into the meter area of the control bay icon
(Controlbay 1), the corresponding Vistonics view opens up, as shown below.
The upper part of the selected control bay icon is highlighted in order to make
clear which bay the operator is looking at.
The SECTION navigator changes to the four-FADER PAGE navigator used
in the control bay view. The global Vistonics VIEW selector of the control
bay is shown next to the central fader.
SW V4.5 Date printed: 27.0.0