Stereo Aux Parameters - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
3.3.5

stereo AUX Parameters

aux s x on/off Stereo AUX bus selection. Other stereo AUX bus views can be selected as
aux s x Rotary The send levels for stereo AUX buses can be adjusted using this rotary
aUX s x Pre/Post When the PRE / POST key in the fader bay's GLOBAL VIEW area is active, the
aUX s x Pan Rotary The Stereo Aux Pan view is activated by pressing the PAN key below the
aUX s x Follow on/off If individual Aux pan settings are required, the default setting ('Follow On',
3-2 Parameters
Press one of the GLOBAL VIEW: AUX STEREO keys.
The stereo AUX view provides selection of the AUX bus (ON/OFF), send
level adjustment, pre-/after-fader switching, and pan setting. From 5.1 sur-
round channels, stereo AUX sends are fed with an ITU-compatible stereo
down-mix.
well (5...8, 9...12, etc.).
encoder; adjustment range is from MUTE (i.e. –∞) through +10 dB.
Vistonics view changes similar to the one shown above in the center. The
™
signal sent to the stereo AUX bus can be selected from PRE (pre-fader, i.e.
before the fader) or POST (post-fader, i.e. after the fader).
GLOBAL VIEW - AUX keys. By default, the Aux panner is linked to the channel
pan value (Follow On), as shown above at the right. If the channel panning
is 'multi-format', only the L/R setting is used for the Aux pan.
i.e. the Aux pan setting follows the channel pan) may be switched off; the
Aux panner is then adjusted with the Vistonics
SW V4.5
rotary encoder.
™
Date printed: 27.0.0