Option: Tc Reader / Generator - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
Metering / Overload LED If 'Shows Entering Headroom' is ticked, the Overload LEDs on the channel
Metering / Headroom Threshold The desired headroom can be set here; this setting doesn't make any level
Metering / Meter History This slider allows setting the speed of the meter history view in four steps
Generator/Level Sets the test signal generator's level to the desired value. Levels can be set
Generator/Frequency: Sets the test signal generator's frequency (sine wave only) to the desired value.
Generator/Signal: Selects the waveform of the test signal generator, from Sine Wave, White
Generator/Defaults: Sets the test signal Generator's level and frequency defaults by using the arrow
4.6.4.2

option: TC Reader / Generator

4-08 GC Operation
strips as well as the red overload sign on the TFT screens illuminates when
the signal level enters the headroom set with 'Headroom Threshold' instead
of an overload condition.
changes but just sets the threshold level of the bargraph meters. Default set-
ting: –9 dB
FS
from 0.5 s/div (fastest) to 5 s/div (slowest). Default: 1 s/div.
to off and, in 1 dB steps, from –90 to +10 dB
turned off by moving the Level slider all the way to the left.
The generator frequency can be set in 1/12
19.95 kHz.
Noise, and Pink Noise.
buttons to adjust the default values.
To quickly apply a level or frequency default, rather than to adjust it manually,
click on the appropriate Defaults button. Default levels can be set in 1 dB
steps, from –90 to +10 dB
the Defaults controls. Default frequencies can be set in 1/12
from 19.95 Hz to 19.95 kHz.
 Tip By default, the Test Signal Generator is patched to GEN (the third channel
input) of all channels. It also appears as a signal source in the General Patch
and can be patched from there to any desired target.
The TC Reader / Generator page is used for adjusting various settings of the
integrated TC reader and generator, such as the time source and frame rate.
SW V4.5
, i.e. 9 dB below clipping occurs.
. The Generator Level cannot be turned off from
FS
. The Generator Level can be
FS
octave steps from 19.95 Hz to
th
octave steps
th
Date printed: 28.0.0