Function Library - Studer Vista 9 Operating Instructions Manual

Library / Available Functions In this area, the functions available from the system library are listed. The
Remove Channels Simply click on the channel type to be removed and hit the 'Del' (delete)
6.4.3.2

function library

Functions Common for Mono and Stereo Channels:
Input Selector 3-way input selector, or
Input Selector PreAmp Ctrl 3-way input selector, with a control interface for D19m or D21m pre-ampli-
Input HPF/LPF & Gain Variable high-pass and low-pass filters, channel gain ±24 dB.
Delay 100 ms VariabIe audio delay 0...100 ms.
Delay 240 ms VariabIe audio delay 0...240 ms.
4-Band EQ Fully parametric 4-Band EQ with Bell/Shelving switch in the LO and HI
4-Band EQ Notch Fully parametric 4-Band EQ with Bell/Shelving switch in the LO and HI
(Standard) Dynamics Full dynamics section with Compressor, Limiter, Expander, Gate, Lookfor-
Vintage Dynamics While the standard Vista dynamics algorithms have been described as rather
Functions for Mono Channels Only:
Input Mode Phase Phase reversal switch.
Multiformat Pan w/LFE Format selection: 2CH, LCR, LCRS, 5.1, EX, 7.1, Amplitude Panning, adjust-
Date printed: 28.0.0
list changes slightly depending on the channel type (e.g. master channels do
not have a Pan function available), but most functions are the same for all
channel types. This means that master channels may be configured with an
EQ, or an Aux master can have a limiter if needed. Functions can be added
to the current channel by double-clicking on the function in the library, or by
using the <<<< button.
Please note that several restrictions to the X-bar section apply:
• The X-bar section can contain a maximum of 6 functions.
• 'Delay 100 ms' and 'Delay 240 ms' must not be used at the same time.
• '4-Band EQ' and '4-Band EQ Notch' must not be used at the same time.
• Standard and Vintage Dynamics cannot be used at the same time.
• 'VSP Surround PAN' requires a lot of DSP power and cannot be used in
a full channel, otherwise an error will be displayed during the Generate
process. It is usually sufficient to remove Dynamics or EQ + Delay func-
tions to allow fitting of the VSP PAN.
key.
 Tip Note how the requirements shown in the 'Core Statistics' area in the Core page
change as you add or remove channels, change their number, or add/remove
functions.
fiers.
Insert Insert function with dry/wet mix feature.
bands, Constant Q/Constant Range switch in the HI-MID and LO-MID
bands.
bands, Constant Q/Constant Range switch in the HI-MID and LO-MID bands,
with additional Notch filter.
ward circuit and Auto Make-up gain, Sidechain with HP/LP Filter.
'transparent', a different dynamics section has been created where in par-
ticular the compressor is utilized in a more pronounced way, i.e., as an effect
itself. This new compressor unit is targeted to be flexible enough for many
different types of sound coloration, including extreme and unusual settings.
Direct Out Direct Channel Output.
Meter Level meter function, switchable to channel input or after fader.
LR Pan Standard Left/Right amplitude panner.
able Divergence and centre usage, Panaround feature, and LFE feed.
SW V4.5
Vista 9 Digital Mixing System
Session Configuration 6-25