Delay And Insert Parameters - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
3.3.7

Delay and insert Parameters

Delay Parameters:
DELAY On/Off is selected with the DELAY hardware key above the Vistonics
DeLaY Rotary Delay time can be set in a range from 0 through 100 ms (or, depending on the
DeLaY time/smpl Selects the delay setting in samples ('smpl' – fine setting) or milli-seconds
3-4 Parameters
Press GLOBAL VIEW: DLY-INS.
This view enables the user to control the delay and insert parameters.
Please note: The two sections are activated with the DELAY and INS hardware
keys above the Vistonics
For 5.1 channels the delay processing block has a maximum delay time of
700 ms (as opposed to the standard 240 or 100 ms delay in the mono or stereo
channels).
The delay value is set using the rotary encoder. It is displayed as a physical
distance (meters) and as a delay time (either samples or milli-seconds).
system configuration, to a maximum of 240 ms). The value is displayed as
a delay distance as well (from 0 cm up to 81.5 m, depending on the system
configuration).
('time' – coarse setting).
SW V4.5
™ section.
™ section.
Date printed: 27.0.0