Mode Entry - Studer Vista 9 Operating Instructions Manual

Vista 9 Digital Mixing System
5.6.5.2

mode Entry

Lo­cal Co­ntro­l Mo­de Entry
Glo­bal Co­ntro­l Mo­de Entry Global Control Mode entry is made as described above. However it should
5-48 AutoTouch+
<Optio­n> • <When Mix Status is Set to on> (also refer to chapter 5.21.2): Radio but-
tons on the Control Modes Options page allow the selection of one of the
following options to take effect when Mix Status is set to on (after the first
time AutoTouch has been turned on for the first time):
<Maintain Object Modes>: When the MIX ON key on the Automa-
-
tion Panel is turned off, all controls are isolated from automation and
operate as manual controls. With <Maintain Object Modes> selected,
knowledge of the Control Mode for each control is maintained. When
the system is turned back on, the Control Mode of all controls is re-
stored.
<Set All to Read>: Turning the MIX ON key on, after having turned it
-
off, will set all controls to READ.
- <Set preselector Objects to WRITE>: Any controls that are selected
in the Global Control Modes preselector will be set to WRITE. All
others will be set to READ.
- <Set preselector Objects to TRIM>: Any controls that are selected in
the Global Control Modes preselector will be set to TRIM. All others
will be set to READ.
• With <Mode Enable sets non-selected to READ> checked on the Control
Modes Options page, all controls not preselected are placed in READ
when a new Control Mode is enabled. In other words, only the controls
that have been preselected will enter the new mode and all others change
to READ.
• <When Loading a Preset>: Radio buttons on the Panel Preset Options page
allow the selection of one of the following options to take effect when a
Panel Preset is loaded:
- <Maintain Object Modes>: Loading a Panel Preset will not change
the control modes of any of the controls in the console. Current modes
will be retained.
- <Set All to Read>: Loading a Panel Preset will set all controls to
READ.
- <Apply Stored Control Mode>: The Control Modes and preselectors
stored within the recalled Preset will be applied.
Refer to chapter 5.6.5.2
be noted that the Global Mode Activators are located in the 'Enable Modes'
section of the Vista automation panel.
SW V4.5 Date printed: 28.0.0