Revert To Factory Default Settings - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
10. To the left of the Upgrade button, click the Browse button.
11. Follow the directions of your browser to locate and select the downloaded firmware file.
WARNING:
After you have started the firmware installation process, do not
interrupt the process. Do not try to go online, turn off the VPN
firewall, or do anything else to the VPN firewall until the VPN
firewall has fully rebooted.
12. Click the Upload button.
The upgrade process starts. During the upgrade process, the Settings Backup and
Firmware Upgrade screen remains visible and a status bar shows the progress of the
upgrade process. The upgrade process can take up to 10 minutes. When the status bar
shows that the upgrade process is complete, it can take another 10 minutes before the
VPN firewall reboots.
(If you can see the unit: The reboot process is complete when the Test LED on the front
panel goes off.)
13. When the reboot process is complete, log in to the VPN firewall again (see
Step 8).
14. To verify the firmware version, select Monitoring.
The Router Status screen displays, showing the new firmware version in the System Info
section.

Revert to Factory Default Settings

To restore the factory default settings you can either use the Factory Defaults reset button
or the web management interface. If you have lost the administration password, you must
use the Factory Default reset button.
Optimize Performance and Manage Your System
551
Step 4 through