Send Syslogs Over A Vpn Tunnel Between Sites - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Monitoring > Firewall Logs & E-mail.
The Firewall Logs & E-mail screen displays.
7. Click the NTP Logs option arrow in the upper right.
The NTP Logs screen displays.
8. To clear the logs, click the Clear Log button.
9. To refresh the information onscreen, click the Refresh Log button.

Send Syslogs over a VPN Tunnel Between Sites

This section describes how to send syslogs from one site to another over a
gateway-to-gateway VPN tunnel.
The high-level steps that describe the actions that you must take to send syslogs from one
site to another over a gateway-to-gateway VPN tunnel, that is, a VPN tunnel between two
VPN firewalls:
1. At Site 1, set up a syslog server that is connected to Gateway 1.
2. At Site 1, set up a VPN tunnel between Gateway 1 and Gateway 2 at Site 2 (see
the VPN Tunnel on Gateway 1 at Site 1
3. At Site 1, change the remote IP address in the VPN policy on Gateway 1 to the WAN IP
address of Gateway 2 at Site 2 (see
Gateway 1 at Site 1
on page 577).
Change the Remote IP Address in the VPN Policy on
on page 578).
Monitor System Access and Performance
576
Configure