NETGEAR ProSafe FVS336Gv2 Reference Manual page 89

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Enable the IPv6 Routing Mode
The following procedure describes how to enable the IPv6 routing mode.

To enable the IPv6 routing mode:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > WAN Settings > WAN Mode.
The WAN Mode screen displays.
7. In the Routing Mode section, select the IPv4 / IPv6 mode radio button.
By default, the IPv4 only mode radio button is selected, and IPv6 is disabled.
Configure the IPv6 Internet and WAN Settings
89