NETGEAR ProSafe FVS336Gv2 Reference Manual page 332

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > UPnP.
The UPnP screen displays.
The UPnP Portmap Table shows the IP addresses and other settings of UPnP devices
that accessed the VPN firewall and that were automatically detected by the VPN firewall:
• Active. A Yes or No indicates if the UPnP device port that established a connection is
active.
• Protocol. Indicates the network protocol such as HTTP or FTP that is used by the
device to connect to the VPN firewall.
• Int. Port. Indicates if any internal ports are opened by the UPnP device.
• Ext. Port. Indicates if any external ports are opened by the UPnP device.
• IP Address. Lists the IP address of the UPnP device accessing the VPN firewall.
7. To enable the UPnP feature, select the Yes radio button.
By default, the No radio button is selected and the feature is disabled.
8. Complete the following fields:
• Advertisement Period. Enter the period in seconds that specifies how often the VPN
firewall must broadcast its UPnP information to all devices within its range. The
default setting is 30 seconds.
• Advertisement Time to Live. Enter a number that specifies how many steps (hops)
each UPnP packet is allowed to propagate before being discarded. Small values limit
the UPnP broadcast range. The default setting is 4 hops.
9. Click the Apply button.
Your settings are saved.
Protect Your Network
331