Additional Wan-Related Configuration Tasks; What To Do Next - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Note: You can configure the VPN firewall to generate a WAN status log and
email this log to a specified address (see
and Event Notifications

Additional WAN-Related Configuration Tasks

If you want the ability to manage the VPN firewall remotely, enable remote management (see
Set Up Remote Management Access
NETGEAR strongly recommends that you change your password (see
and Automatic Logout Period
Test the VPN firewall before deploying it in a live production environment. Verify that network
traffic can pass through the VPN firewall:by doing the following:
• Ping an Internet URL.
• Ping the IP address of a device on either side of the VPN firewall.

What to Do Next

After you complete setting up the IPv6 WAN connection for the VPN firewall, the important
tasks that are described in the following chapter and sections you might want to address
before you deploy the VPN firewall in your network:
• Chapter 2, Configure the IPv4 Internet and WAN Settings
• Chapter 4, Configure the IPv4 LAN Settings
• Configure Authentication Domains, Groups, and User Accounts
• Manage Digital Certificates for VPN Connections
• Use the IPSec VPN Wizard for Client and Gateway Configurations
• Chapter 9, Set Up Virtual Private Networking with SSL Connections
on page 567).
on page 534). If you enable remote management,
on page 511).
Configure the IPv6 Internet and WAN Settings
114
Manage Logging, Alerts,
Change Passwords
on page 488
on page 512
on page 334