NETGEAR ProSafe FVS336Gv2 Reference Manual page 343

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2

To set up an IPv6 gateway-to-gateway VPN tunnel using the VPN Wizard:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select VPN > IPSec VPN > VPN Wizard.
The VPN Wizard screen displays the IPv4 settings.
7. In the upper right, select the IPv6 radio button.
The VPN Wizard screen displays the IPv6 settings. The following figure shows an
example that does not relate to other examples in this manual.
Set Up Virtual Private Networking With IPSec Connections
341