NETGEAR ProSafe FVS336Gv2 Reference Manual page 291

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
12. Repeat the previous two steps to add more IP addresses to the IP Addresses Grouped
table.
13. Click the Edit button again.
The IP Groups screen displays. The group configuration is complete.
Change an IP Address Group
The following procedure describes how you can change an existing IP group.

To change an IP group:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Services > IP Groups.
The IP Groups screen displays.
7. In the Custom IP Groups Table, click the Edit button for the IP group that you want to
change.
The Edit IP Group screen displays.
8. Change the settings.
You can change the group name and you can change the group type. You cannot change
an IP address that is associated with the group but you can remove the IP address and
replace it with another IP address.
9. To remove one or more IP addresses that are associated with the group and add new IP
addresses, do the following:
a. In the IP Addresses Grouped table, select the check box to the left of each IP address
that you want to remove, or click the Select All button to select all IP addresses.
b. Click the Delete button.
Customize Firewall Protection
290