NETGEAR ProSafe FVS336Gv2 Reference Manual page 54

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Your settings are saved.
The protocol binding rule is added to the Protocol Binding table. The rule is automatically
enabled, which is indicated by a green circle in the ! status icon column.
Change a Protocol Binding Rule
The following procedure describes how to change an existing protocol binding rule.

To change a protocol binding rule:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > Protocol Binding.
The Protocol Bindings screen displays.
7. In the Protocol Bindings table, click the Edit button for the binding that you want to change.
The Edit Protocol Bindings screen displays.
8. Change the settings.
For more information about the settings, see
Interfaces on page 51.
9. Click the Apply button.
Your settings are saved. The modified protocol binding displays in the Protocol Bindings
table on the Protocol Bindings screen.
Manage Existing Protocol Binding Rules
The following procedure describes how to enable or disable existing protocol binding rules or
remove protocol binding rules that you no longer need.
Configure the IPv4 Internet and WAN Settings
54
Configure Protocol Binding Rules for IPv4