NETGEAR ProSafe FVS336Gv2 Reference Manual page 400

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Setting
Integrity Algorithm
Local IP Address
Local Subnet Mask
9. Click the Apply button.
Your settings are saved. The new Mode Config record is added to the List of Mode Config
Records table.
Continue the Mode Config configuration procedure by configuring an IKE policy. (You can
also change an existing IKE policy.)
10. Select VPN > IPSec VPN.
The IPSec VPN submenu tabs display with the IKE Policies screen for IPv4 in view.
11. To add an IKE policy for IPv6 instead of IPv4, in the upper right, select the IPv6 radio button.
The IKE Policies screen for IPv6 displays.
12. Under the List of IKE Policies table, click the Add button.
The Add IKE Policy screen displays. The Add IKE Policy screen for IPv4 is identical to the
Add IKE Policy screen for IPv6.
Note: You can configure an IPv6 IKE policy to assign IPv4 addresses to
clients, but you cannot assign IPv6 addresses to clients.
Set Up Virtual Private Networking With IPSec Connections
Description
From the menu, select the algorithm to be used in the VPN header for the
authentication process:
• SHA-1. Hash algorithm that produces a 160-bit digest. This is the default
setting.
• MD5. Hash algorithm that produces a 128-bit digest.
The local IP address to which remote VPN clients have access. If you do not specify
a local IP address, the VPN firewall's default LAN IP address is used (by default,
192.168.1.1).
The local subnet mask. Typically, this is 255.255.255.0.
Note: If you do not specify a local IP address, you do not need to specify a subnet
either.
398