NETGEAR ProSafe FVS336Gv2 Reference Manual page 347

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Figure 10. Example of an IPv4 client-to-gateway IPSec VPN connection
The VPN firewall supports client connections with the NETGEAR ProSAFE VPN Client, which is
an application that you can install on a computer.
The VPN firewall is bundled with a single-user license of the NETGEAR ProSAFE VPN Client
software (VPN01L). For information about the NETGEAR ProSAFE VPN Client, including
information about multi-user licenses, visit
http://www.netgear.com/business/products/security/vpn-software.aspx.
Note: The NETGEAR ProSAFE VPN Client supports IPv4 only; a future
release of the VPN Client might support IPv6.
Setting up an IPv4 client-to-gateway connection includes two tasks:
1. On the VPN firewall, use the IPSec VPN Wizard to set up a connection to the client (see
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
2. On the computer that has the VPN ProSAFE Client installed, set up a connection to the
VPN firewall. You can use one of two methods, which are described in the following
sections:
• Use the NETGEAR ProSAFE VPN Client Wizard to Create a Secure Connection to
the VPN Firewall
• Manually Create a Secure Connection to the VPN Firewall Using the NETGEAR
ProSAFE VPN Client
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
The following procedure describes how to set up thew VPN firewall for a client-to-gateway
VPN tunnel using the VPN Wizard.
Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
Set Up Virtual Private Networking With IPSec Connections
on page 349
on page 354
345
on page 345).